Tips To Understanding Pulse Irrigation
by Eliza Mendoza
As the world population grows so does the need for more food. This growth is coupled with a reduction in arable land as people settle and build homes where farming should be done. This forces mankind to come up with better farming methods that will take less space and produce more food. Systems like pulse irrigation has proven to be just one of the ways to make land more productive while using little water.
This is a type of irrigation that makes it possible to manage your water usage. It can be scaled to whatever flow one requires so as to greatly minimize water flow. It can be used with sprinkler or drip irrigation very effectively. The traditional low flow systems and even ultra low flow systems of irrigation can be used with this pulse system.
For areas with very scarce water like in the deserts, this system has proven to be effective in saving water while satisfying the plants. The operation works by allowing water to passively flow into a reservoir at controlled rate. This builds pressure steadily till it reaches a predetermined level. The pressure then forces open the outlet valves and a pulse of water goes out.
The flow gradually lowers the pressure hence the valve closes again so that the reservoir can recharge again. The inflow is kept below the outlet flow therefore the cycle is maintained. A drip flow controller is used at the inlet managing the rate at which water flows into the reservoir therefore the timing.
As long as the system is properly installed, it will not need any monitoring. This system keeps the plants from overwatering. This constant, controlled and frequent water flow reduces the plant demand for water and lowers usage of water. The plants also do not experience water stress due to the intermittent supply.
Basically, this system operates by the strong magnets that attaches to the outlet valve. These holds it closed as the pressure builds. When it is strong enough, the reservoir pressure forces the top magnets open. As the pressure reduces, it drops down thereby closing the valve again allowing the recharging to start.
When used with a sprinkler system, the results are impressive. During seed germination, it can be set to sprinkle for 5 seconds every minute in the first two weeks after planting. This is then gradually adjusted till you can allow it to sprinkle for an 8 hour period three times a week. The basic determinants are the rain conditions, intensity of the sun and water need by the plant.
This <A href="http://pulsecaremedical.com">pulse irrigation</A> system has numerous advantages. Used with a sprinkler or even drip irrigation system, it has no run offs. Used o sandy soil, there is no chance for leaching or water loss in the loose soil. When used on hilly areas and on shallow soil, water does not run off. In order to achieve temperature control, use intermittent sprinkling and foggers to perform evaporative cooling I hot conditions. The system also allows for the use of less space in greenhouses and containers. Lower capacity pumps and smaller conduits can be used therefore reducing installation costs.
<a href="http://pulsecaremedical.com">Read more about</a> The Effectiveness Of Pulse Irrigation.
---------------------------------------------------
You are receiving this because you signed up for it on 2013-07-23 from IP 197.206.251.134
To fine-tune your selection of which articles to receive, just login here:
http://www.uniquearticlewizard.com/bloggers/
using your username:
To unsubscribe please use the following link:
http://www.uniquearticlewizard.com/unsubscribe.php?mail=maxblogmax.madani@blogger.com&code=16554a6308a09067f2e4e4003fca1ea3
---------------------------------------------------
No comments:
Post a Comment